When it comes to hobbies, few are as rewarding as woodworking. You can turn yourself a beautiful railing, create a jewelry box for your daughter or create a new dining room table which perfectly matches your renovated flooring. Regardless of the project you want to tackle, the tips below will help you find success.
Use stop blocks to your advantage for more accurate work. When cutting a lot of pieces the same size, no matter how carefully you measure, you often find small variations. Use a pre-cut stop block to make those measurements pinpoint accurate. Then the table saw will stop at just the right length length.
Try using duct tape to create a level spot. If you’ve used your table saw on a base that’s mobile, you should be able to easily pull it in and out. To really finish it up, find a level spot on your floor. This also helps you saw boards without obstruction. Mark your wheel positions using duct tape that is brightly colored, and then roll the saw to that same flat spot each time you need to saw.
Use some affordable filters for collecting fine dust. The filters and micro-filtering bags made to catch this dust can get pricy after several replacements. Try using the ones that are sold for use in household vacuums.
You can buy the cheap ones and easily modify them to fit your shop vacuum. Cut off the top a bit past the small opening. Turn the whole thing inside out so that airflow still flows in the usual direction. Slip it over your foam filter using the retaining ring to keep it in place.
Have some more spring when you’re working with your grip. You may sometimes want to use spring clamps, but this can restrict the freedom of your hands. These clamps can be difficult to open without the use of both hands. However, it can be made easier. Before you start to glue, put your clamps on some scrap wood while you have two free hands. In this way, you will be able to retrieve them with one hand as you need them.
Do you lose drill press key chucks often? A good way to keep them within reach is to drill a hole somewhere on the drill press they fit. On top of the press is a good place, where you can see it. Drill a small hole the exact same size of the chuck’s crossbar and it will fit in perfectly.
Use a socket when drawing an arc. Most shop owners have a variety of sockets that can be used for a variety of radii. For example, if you are wanting a radius of 10 millimeters, reach into your toolbox and grab a metric socket that size. You will get a perfect arc each time using this technique.
From a tiny match box to a new deck for your backyard, working with wood provides you with tangible rewards which show how skilled you are. In order to better those skills, use the ideas mentioned here and start working smarter. In no time, you’ll find that you are able to achieve even greater results.…